Jet Company Manufactures Grain, Flatbed, Dropdeck, Detachable, Side Dump and Tag Trailers

DROPDECK TRAILERS

Jet Company specializes in standard as well as custom designed trailers. We offer Dropdecks and Double Dropdecks in a wide choice of sizes, configurations and colors. Our high performance trailers are designed for Big Payloads. Working with customers is Jet's specialty.


What makes JET Dropdeck Trailers better than the competition:
Advanced Engineering (stronger, lightweight, heavier payload)		Specialized trailers to fit your needs
High resale value		Pride and satisfaction knowing you're working with a reputable company that has been in business since 1952.
Quality workmanship
Proven performance (Jet tested trailers with 115,000 lbs. of steel in an 8' area over a grueling test track to insure reliability.)		Customer service - at Jet Company we're always looking for tomorrow's business.

	Up to 53' (longer lengths upon request)
	96" or 102" standard
	Main Beam - High strength material. Ranges from 24"-28" deep in center.
	4" high strength aluminum extrusion or 4" high strength steel. Crossmembers are available on 12", 14", 16" or 18" centers.
	6" side high strength aluminum extrusion, 6" steel channel, 8.2 lbs./ft. The siderail is the winch track on both sides.
	Rubrail - 3/8" x 2-1/2" high strength aluminum extrusion or 3/8" x 2" steel
	Stake Pockets - Spaced 24" apart with pipe-spool. ID 1-5/8" x 3-7/16"
	30" Kingpin standard. Other settings available.
	Axles - 22,500 lb rating for spring suspensions, 24,000 lb rating for air ride suspension
	Air ride suspension available in closed tandem or 10'1" spread. Spring suspension available in closed tandems.
	Two speed landing legs. Ultimate load capacity 140,000 lbs.
	1-1/4" extruded aluminum floor, 1-1/8" apitong floor or 2" nominal oak floor. 5/16" zinc plated floor screws
	Kneebraces approximately every 4' supporting outside rail
	Mylar tape is placed between steel and aluminum components. Aluminum components have a natural finish.
	Protected wire harness lights. Sealed tail lights. Sealed marker lights. All connections are sealed. Rear lights enclosed in protective closures.
	Heavy duty rubber bumpers, located on outside corners.
	Mudflaps on both axles on 10'1" spread, Anti sail type

	Tire Carrier		Sliding Winches
	Beavertail		Rope Hooks
	Lift Axles		Recessed Tie Downs
	Winch Straps		D-Rings
	Sliding Tandems		Intraax Suspension
	Manual Dump Valve		10'1" Spread
	Air Ride Suspension		Optional Colors
	Spring Suspension		Aluminum Wheels
	Closed Tandem		Additional Rear Lights
	Coil Package		Slanted Drops
	Lower Deck Heights		Tri Axle
	Twist Locks		Ramp Holders
	Tool Boxes
	Spring Assist Hinged Ramps
	Load Levelers
	Dura Lite Hubs w/Centrifuse Drums
	Dual Tire Equalization System
	Manual Raise and Lower Valve
	Additional Side Marker Lights
	2" Nominal Oak or 1-1/4" Apitong Floor
	Bulk Head
	12-1/4" x 7-1/2" Axles

Standard Beam Rating*
Concentrated Weight in Feet	4'	10'	20'	Evenly Distributed
	ratings based on a 48' trailer with 3/8" x 5" top and bottom flange with 10'1" spread and 30" kingpin
	50,000 lbs.	53,000 lbs.	58,000 lbs.	80,000 lbs.

*Higher Beam Ratings are Available